BW09 Bluetooth bracelet with caller ID function and time display China mobile phone

The bracelet will vibrate and show caller's number when you have an incoming call.

The bracelet will vibrate and show caller's number when you have an incoming call. Bluetooth bracelet comes with a built in rechargeable battery. Before using this bracelet for the first time, please charge the battery fully ( approximately 2 -3 hours).

How to charge
To charge the bracelet, please plug the appropriate end into the bracelet charge slot on the bracelet and another end to computer USB port or adapter USB port.

Normal charging time
The bracelet will normally take 1 hour for charge. When the battery is fully charged, the screen will display "Charge OK".

Charge indication
The screen will first show "charger in", and then show "charging".

Standby time
Up to 60 hours standby time. Please note the standby time is effected by how often the bracelet vibrates and screen display.

Low battery notification
When the battery is lower power, the screen will show "low battery". Please charge the bracelet when the bracelet indicates "low battery".

Turning ON/OFF
Push the button on left side for 2 seconds until the screen shows "power on" and push the same button for 2 seconds to turn off the bracelet.

Setup time
Push the button on the right side of the bracelet to setup time. Push button left button to set hour, push button on the right side to set minute. Push button on the right side again to exit time setup mode.

Connect bracelet with mobile phone
Keep bracelet within the range of 1 meter around the mobile phone
Ensure the bracelet is powered on
Push left button for 4 seconds till the screen show "pairing".
Search for bluetooth device in your phone, the bracelet will be found the device  named as "Bracelet".
Establish the connection.
Enter the password 0000.
Confirm the connection and authorize it.
When connection success when "mobile no" displayed on the bracelet screen and a earphone sign will appear on the screen of the bracelet.

If connection failed, the screen will show "pair fail" and "no connect".

Connection loss
Earphone sign will disappear from the bracelet screen when connection losses and the bracelet will vibrate.